Electronics & 3D Printers
96 products
Price on request
Back-illuminated and stacked CMOS 12-megapixel image sensor (Sony IMX708) High signal-to-noise ratio (SNR) Built-in 2D Dynamic Defect Pixel Correction (DPC) Phase Detection Autofocus (PDAF) for rapid autofocus QBC Re-mosaic function HDR mode (up to 3 megapixel output) CSI-2 serial data output 2-wire serial communication (supports I2C fas…
Price on request
Technical parameters: Working voltage: DC5V Working current: 30mA(MAX) Response time: <500ms Insulation resistance: 100MΩ[Min]; Output mode 1: Analog output 0-4.5V Output mode two: High/low signal High: 5V Low: 0V Operating temperature: -30℃ -80 ℃; Storage temperature: -10-80 ℃.
Price on request
Without dupontt case Optical Sensor Technology: infrared Lens: Wide Angle, Fixed Real Angle of View: 15 Degrees Connector Type:DC power connector Optical Sensor Size: 1/4 inch
Price on request
XD‑35 Thermoelectric Peltier Plate Module Cooling System DIY Kit for Small Space Cooling Cooling Power: 60W Input Voltage: 12V Cooling Fan Size: 90 x 90 x 25mm / 3.5 x 3.5 x 1in Material: ABS + aluminum alloy
Price on request
ATmega32U4 microcontroller with native USB interface 16 MHz operating frequency for stable real-time control Nine 10-bit ADC channels for analog signal acquisition Five PWM outputs for precise actuator control Compact 33 × 18 mm layout suitable for wearable devices UART, I2C, and SPI communication interfaces Onboard voltage regulator sup…
Price on request
24-20 Gauge Stranded Tinned Copper Wire 5 Colors 16.4ft/5m Each
Price on request
Function: 12v air pump electric aquarium vacuum, large air volume, good performance. Mini size design, with inlet and outlet on the body Air pressure pump for easy installation and use.
Price on request
1x Raspberry Pi 5 Model B 2GB 1x Raspberry Pi 5 Power Adapter - 27W (USB-C) 1x Micro HDMI to Standard HDMI (A/M) 1m Cable 1x Official Raspberry Pi 5 case with fan - Red & White 1x 32GB Micro SD Card
Price on request
1x Raspberry Pi 5 Model B 4GB 1x Raspberry Pi 5 Power Adapter - 27W (USB-C) 1x Micro HDMI to Standard HDMI (A/M) 1m Cable 1x Official Raspberry Pi 5 case with fan - Red & White 1x 32GB Micro SD Card
Price on request
1x Raspberry Pi 5 Model B 8GB 1x Raspberry Pi 5 Power Adapter - 27W (USB-C) 1x Micro HDMI to Standard HDMI (A/M) 1m Cable 1x Official Raspberry Pi 5 case with fan - Red & White 1x 32GB Micro SD Card
Price on request
1x Raspberry Pi 5 Model B 16GB 1x Raspberry Pi 5 Power Adapter - 27W (USB-C) 1x Micro HDMI to Standard HDMI (A/M) 1m Cable 1x Official Raspberry Pi 5 case with fan - Red & White 1x 32GB Micro SD Card
Price on request
Technical Specifications: 1.5GHz 64-bit quad-core CPU 2GB RAM 2.4 GHz and 5.0 GHz IEEE 802.11ac wireless, Bluetooth 5.0, BLE Gigabit Ethernet 2x USB 3.0 ports; 2x USB 2.0 ports. Raspberry Pi standard 40 pin GPIO header 2 × micro-HDMI ports (up to 4kp60 supported) 2-lane MIPI DSI display port 2-lane MIPI CSI camera port 4-pole stereo audi…
Price on request
There are no reviews for this product. Write a review
Price on request
Electrical Wire Cable Cutters with Flush Nipper Side Snips (13.2x8cm)
Price on request
2V DC Water Heater With Alligator Clip Cartridge Heater 150w Stainless Steel Portable Immersion Heater for Car Truck. Suitable for 400ml of water and less.
Price on request
Time-of-Flight -Breakout 940nm GY-VL53L0X Laser Distance Module I2C IIC GY-530 3.3V/5V
Price on request
Working Voltage: DC5V. Quiescent Working Current: 5mA. Total Working Current: 30mA. Wave Transmit Frequency: 40kHz. Max. Measuring Distance: 5m. Blind Zone: 25cm. Size: 28.5*41mm. Resolution: Approx 0.5cm. Angle: <50 degree. Working Temperature: -10℃~70℃. Storage Temperature: -20℃~80℃.
Price on request
Thin Film SF45-65 Pressure Sensor High Sensitive Flexible Type Force Sensitive Resistor Square Shape Pressure Sensor
Price on request
Size: 25x35cm, S-140 with magnetic Color: Blue Features: High temperature resistance,soft texture and high stability Material: Silicone Several hole locations to set screws, IC chips and small parts.
Price on request
There are no reviews for this product. Write a review
Price on request
MAX7219 8x8 Dot Matrix Module 4-in-1 Common Cathode LED Display Red with Dupont Cables for Arduino/MCU Projects
Price on request
There are no reviews for this product. Write a review
Price on request
Adapter 3P+1m waterproof cable Power supply: 3.0 V to 5.5 V
Price on request
Elecrow USB-HD Connector for 5 inch Raspberry Pi Screen Display DIY HDMI-Compatible Adaptor- Raspberry Pi 2B/3B/3B+/4B
